Economic Benefits

-----------------------

(Results may vary depending on engine, driving and operating conditions)


Gasoline Automobile Engines

(Given: 15,000 miles/year, 20% increase in fuel efficiency from 15mpg to 18 mpg, Avg. Fuel Cost = $1.35/gallon, 50,000 miles between GENESIS applications)


Large Diesel Engines

Given: 100,000 miles/year, 20% increase in fuel efficiency from 5mpg to 6mpg, Avg. fuel cost = $1.40/gallon, 50,000 miles between GENESIS applications.


Installing GENESIS

  1. Install GENESIS just prior to changing the engine oil
  2. Insure engine oil is full. If it is not, top-it-off. (VERY IMPORTANT)
  3. Start the engine and run until the top radiator hose is hot.
  4. Increase engine revolutions from idle to about 1500 rpm and hold at that level
  5. Maintaining the engine revolutions at about 1500 rpm, slowly add GENESIS to the oil over a 2 minute period
  6. Continuing running the engine for NO MORE THAN 20 minutes at about 1500 rpm OR drive for NO MORE than 20 miles on the highway
  7. IMMEDIATELY, perform a normal oil & FILTER change while the engine is hot. (carbon & sludge are caught in the old oil and oil filter - they need to be removed)
  8. That's it!

Benefits from GENESIS will appear within minutes after installation (smoother running engine, more power, lower hydrocarbon emissions, etc.) GENESIS benefits will continue for up to 50,000 miles, depending on engine, driving and operating conditions.


[ What is GENESIS? | Common questions ]
[ GENESIS uses | Economic benefits ]
[ Letters of Endorsement | Testimonials ]
[ Competitive Analysis | Report on GENESIS ]
[ Laboratory Analysis | Test summary | Developing a tester ]
[ GENESIS Home | Nasachem Products Home ]


For comments or problems contact: nasachem@ghg.net

Copyright © 1996 Genesis Products Company All rights reserved.